ToolsDevice checks

Mouse Test

Point at the box and click every button, then scroll up and down. Each part of the mouse lights up when it works.

Click here
0Left
0Right
0Middle
0Back
0Forward
0Scroll up
0Scroll down
0Unwanted double-clicks

How to test a mouse

A mouse test shows which buttons and wheel movements your computer receives. If a button lights up and its counter goes up once per click, it works. If one click sometimes counts as two, the switch is wearing out and the test reports an unwanted double-click.

  1. Point at the box. Click left, right and the wheel (middle).
  2. Press the side buttons (Back and Forward) if your mouse has them.
  3. Scroll a few notches up, then down.
  4. For the double-click check, single-click the left button about 30 times at a normal pace and watch the red counter.

How the double-click check works

Nobody clicks the same button twice within 80 milliseconds on purpose; a worn switch can. When two presses of one button arrive closer than 80 ms, the test counts an unwanted double-click.

Result after 30 single clicksWhat it means
0The switch is fine
1 – 2Early wear; test again later
3 or moreWorn switch: expect dragging and selecting to fail

A button does not respond?

  • Side buttons: some mice need their own software for these to send Back and Forward.
  • Wireless mouse: replace or charge the battery and move the receiver closer.
  • Try another USB port or another computer to rule out the computer.

Questions

Does the right-click menu open?

No. Inside the test box the browser menu is blocked so you can count right-clicks.

Can I test a laptop touchpad?

Yes. Tap or press for left click, use two fingers for right click and scroll; the box shows what the touchpad sends.

Why does the scroll count jump by more than one?

Smooth touchpads and free-spinning wheels send many small scroll steps. The counter counts scroll events, not wheel notches.

More tools